Eurotech VoIP2 AII Series Bedienungsanleitung PDF herunterladen (Seite 10)

2009

EUROTECH USER MANUAL

VoIP

All™ Series: 4 Channel Gateway User Manual 10

Chapter 1: Installing SIM Cards & Connecting Cables

Chapter 1.1: Hardeware Overview

The gateway consists from four main parts:

The Master – Contains a AudioCodes™ DSP processor with a Linux based operating

system. Using a Linux operating system run the ‘v2g’ program that operates the

gateway.

· The Slave – Contains 4 cellular ports. Each port has one local SIM. Each card has one

antenna connection for all 4 ports. The card is controled by two programble processors.

Chapter 1.2: Installing the SIM Cards

Insert the SIM cards into the VoIP

ALL as follows:

Each cellular port has 1 local SIM.

On the bottom of the each cellular port, there are labeled slots for the local SIMs.

Position the SIM in the slots so the SIM metal contacts face upward and the snubbed

triangle inwards into the device.

Gently insert the SIM until you hear a click.

The SIM is now in place.

Note: To extract the SIMs you need to push and release the SIM, the SIM will be released from the switch, and then pull it

out.

Chapter 1.3: Connecting the Cables

Connect the cables to the VoIP2ALL gateway as follow:

LAN cable - The LAN cable is used to connect the system to the internet network.

Connect the LAN line to the RJ-45 marked LAN.

Antenna – Connect one antenna for all the four channels. Position the antenna more

then 1.5 meters from the VoIP

ALL.

Power Supply - Connect the power supply from your 110-240V 50-60Hz power outlet to

the VoIP

ALL Gateway power connector.

Com Cable – Connect the Com Cable from the PC RS-232 comport to the RJ-45 marked

COM. The com connection is not essential for day to day use.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 63 64

Keine Kommentare

Eurotech VoIP2 AII Series Bedienungsanleitung Seite 10